Building Materials

Coarse-thread bugle-head drywall screws with a sharp point and black finish, the usual choice for fastening drywall to wood framing. This listing i...

Wall angle is the perimeter trim for a suspended acoustical ceiling. The L-shaped section fastens to the walls around the room and carries the cut ...

An empty sand bag supplied flat and filled on site, used wherever loose ballast or a temporary water barrier is needed. Filled roughly two-thirds f...

A rebar hook sized for #6 reinforcing bar, sold individually. The #6 designation follows the standard bar-size convention in which the number gives...

Black Jack Wet/Dry Surface Roof Cement is an asphalt-based plastic roof cement supplied in a cartridge for gun application. It is the patching comp...

Protective caps that slip over the exposed ends of vertical or horizontal reinforcing bar on a jobsite. Cast-in-place work routinely leaves dowels ...

A ready-to-use white stucco finish coat supplied in a bucket, formulated for a fine texture. Finish coats are the final layer in a stucco assembly,...

A main beam hanger is the connector that ties a suspended ceiling main runner back to the structure above. It is installed at the hanger points alo...

A main beam hanger is the suspension fitting that ties a ceiling grid main beam or main runner back to the structure above. One end engages the bea...

The main beam hanger is a small suspension accessory used in acoustical ceiling and drywall grid work. It ties the main runner of a suspended grid ...

L-bead is an L-shaped drywall trim used to finish an exposed panel edge where the board stops against a dissimilar surface — a window or door jamb,...

A face mount joist hanger is a formed metal connector used to carry the end of a joist off a header, beam or ledger. The stirrup cradles the bottom...

A joist hanger is a formed steel connector that carries the end of a joist, header or beam off the face of a supporting member. The U-shaped seat c...

A joist hanger is a formed sheet-steel connector that carries the end of a joist where it meets a header, rim board, beam or ledger. The back flang...

A joist hanger is a formed sheet-metal connector that supports the end of a joist where it meets a header, beam or ledger. The U-shaped seat carrie...

A galvanized steel joist hanger sized for a doubled 2 in. x 8 in. carrier member, used to hang joists, headers and trimmers from a beam, ledger or ...

A joist hanger is a formed metal bracket that carries the end of a joist where it meets a header, beam or ledger, transferring the load through the...

A galvanized steel joist hanger sized to receive a built-up carrier of two nominal 2 in. x 10 in. members. The hanger wraps the end of the joist an...

USG ready-mixed drywall joint compound, supplied wet in a resealable plastic pail. The material comes premixed to a spreadable consistency, so it c...

Ready-mixed joint compound for taping, filling and finishing gypsum board seams. It is supplied premixed in a sealed pail, so it needs only stirrin...

Insulation supports are stiff spring-wire rods that hold batt insulation up in a framing cavity without staples, twine or netting. The wire is cut ...