Doors & Windows

A surface-mounted door sweep consisting of an extruded aluminum retainer with a flexible seal blade along its lower edge. The retainer screws to th...

The ZipWall ZipDoor is a self-adhesive zippered barrier that closes off a doorway during remodeling, demolition, restoration or abatement work. A p...

Boring a door for a lockset or deadbolt takes two intersecting holes: a large cross bore through the face of the door and a smaller edge bore throu...

A rigid door stop is the simplest form of wall protection for a swinging door: a fixed metal post with a cushioned tip that stops the door leaf bef...

A rigid door stop is the simplest form of door control hardware: a solid, one-piece post that mounts to the baseboard, wall, or floor and takes the...

A spring door stop is the simplest way to keep a knob or lever from punching through drywall. The coil-spring body mounts to the baseboard behind t...

A hinge pin door stop is a swing limiter that mounts to the door's existing butt hinge rather than to the floor, the baseboard or the door face. Th...

A hinge pin door stop is the least invasive way to keep a door from driving its knob into the drywall. The unit clamps to the barrel of an existing...

A wall-mounted door bumper is the simplest form of door protection: a small resilient stop that mounts on the wall surface where the door or its kn...

A convex wall door stop is a surface-mounted bumper that takes the impact of a swinging door before the knob, lever or door edge reaches the wall. ...

A wall-mounted door bumper is the simplest way to stop a swinging door before the knob, lever or edge reaches the wall behind it. The unit fastens ...

A low dome floor stop is the squat, rounded bumper set into the floor behind a swinging door. The dome body takes the strike from the door face or ...

A dome stop is the simplest piece of door hardware there is: a solid, rigid bumper that fastens to the floor behind a swinging door and takes the i...

A flip down door holder, also called a kick down holder, is a surface-mounted device that keeps a swinging door propped open without a separate flo...

A kick-down door holder is a surface-mounted device fastened to the face of a door near the bottom rail. A hinged arm is pivoted down with a foot u...

A hotel door guard is a secondary latching device mounted on the inside face of an entry door and its frame, used in addition to the primary lockse...

A door guard is the swing-bar style secondary latch mounted on the inside face of an entry door, most often specified for hotel, motel and apartmen...

A chain door guard is a surface-mounted secondary security device for a swinging entry door. A short length of chain runs between a plate fastened ...

A chain door guard is a simple secondary latch for a swinging entry door: a slide plate mounts to the door face and a chain-and-ball assembly mount...

A spring hinge replaces a standard butt hinge and returns the door to the closed position on its own, using a coiled spring housed inside the barre...

A flip-down door holder, also called a kickdown holder, mounts to the face of a door near the bottom rail and swings a pivoting arm down to the flo...

A square-corner butt hinge in stainless steel, sized for residential interior and light commercial doors. Butt hinges mount in mortises cut into th...

A stainless steel butt hinge for hanging interior and exterior doors. The leaves carry a quarter-inch corner radius, which matches the router templ...

A door sweep is the strip that closes the gap between the bottom of a door and the threshold or finish floor. This one is a brush-type sweep: an ex...