Metal Framing & Accessories

Wall angle is the perimeter trim for a suspended acoustical ceiling. The L-shaped section fastens to the walls around the room and carries the cut ...

A main beam hanger is the connector that ties a suspended ceiling main runner back to the structure above. It is installed at the hanger points alo...

A main beam hanger is the suspension fitting that ties a ceiling grid main beam or main runner back to the structure above. One end engages the bea...

The main beam hanger is a small suspension accessory used in acoustical ceiling and drywall grid work. It ties the main runner of a suspended grid ...

A face mount joist hanger is a formed metal connector used to carry the end of a joist off a header, beam or ledger. The stirrup cradles the bottom...

A joist hanger is a formed steel connector that carries the end of a joist, header or beam off the face of a supporting member. The U-shaped seat c...

A joist hanger is a formed sheet-steel connector that carries the end of a joist where it meets a header, rim board, beam or ledger. The back flang...

A joist hanger is a formed sheet-metal connector that supports the end of a joist where it meets a header, beam or ledger. The U-shaped seat carrie...

A galvanized steel joist hanger sized for a doubled 2 in. x 8 in. carrier member, used to hang joists, headers and trimmers from a beam, ledger or ...

A joist hanger is a formed metal bracket that carries the end of a joist where it meets a header, beam or ledger, transferring the load through the...

A galvanized steel joist hanger sized to receive a built-up carrier of two nominal 2 in. x 10 in. members. The hanger wraps the end of the joist an...

Furring channel clips are the small spring-steel connectors used to tie hat-shaped furring channel to the carrying channel in a suspended or direct...

A galvanized steel joist hanger sized for nominal 2 in. by 12 in. framing lumber. The hanger wraps the end of the joist and transfers its load into...

Aluminum angle in an 8 ft. length with a 1-1/2 in. leg, pre-punched with a row of holes along its length. The holes let the piece be fastened with ...

An offset angle bracket is a formed metal framing connector with two flanges joined at an angle and a step, or offset, between them. The offset let...

The Simpson Strong-Tie A21Z is a formed steel framing angle from the company's A-series of general-purpose connectors. It is a single piece of shee...

Hurricane ties are the small formed-steel connectors that tie the roof framing down to the wall below, so that uplift from wind does not simply lif...

The H2.5A is a single-sided sheet-metal hurricane tie from Simpson Strong-Tie, used to tie a rafter or truss down to the wall top plate so roof fra...

The Simpson Strong-Tie LS70 is a skewable reinforcing angle from the LS series, a light connector used where two wood framing members meet at somet...

The A23 is one of Simpson Strong-Tie's A-Series framing angles \u2014 a short, formed steel angle bent to 90 degrees and punched with fastener hole...

Attach a 4x4 wood post to existing concrete with the Simpson Strong-Tie ABA44Z adjustable post base. Its built-in 1-inch standoff helps prevent rot...