Exterior Products

A left-hand end cap closes off the open end of a run of K-style gutter, sealing the trough so water is carried toward the outlet rather than spilli...

Flashing cement is a heavy-bodied asphalt mastic used to seal and bond roof flashings, laps and repairs. It trowels on thick, clings to vertical an...

A hydraulic door closer mounts to the door and frame and controls the door through its swing, bringing it back to the latch under its own power rat...

A door sweep is a surface-mounted weatherseal that closes the gap between the bottom of a door and the threshold or sill. It consists of an aluminu...

A surface-mounted door sweep consisting of an extruded aluminum retainer with a flexible seal blade along its lower edge. The retainer screws to th...

Drip edge is the L-shaped metal flashing installed along eaves and rakes to carry runoff clear of the fascia and sheathing edge. The short leg hook...

Drip edge is the L-shaped metal flashing installed along the eaves and rakes of a roof to direct runoff away from the fascia and into the gutter. T...

Aluminum flashing is thin, formable sheet metal used to close the joints where a roof meets a wall, a chimney, a valley or a penetration, directing...

The ZipWall ZipDoor is a self-adhesive zippered barrier that closes off a doorway during remodeling, demolition, restoration or abatement work. A p...

Boring a door for a lockset or deadbolt takes two intersecting holes: a large cross bore through the face of the door and a smaller edge bore throu...

A rigid door stop is the simplest form of wall protection for a swinging door: a fixed metal post with a cushioned tip that stops the door leaf bef...

A rigid door stop is the simplest form of door control hardware: a solid, one-piece post that mounts to the baseboard, wall, or floor and takes the...

A spring door stop is the simplest way to keep a knob or lever from punching through drywall. The coil-spring body mounts to the baseboard behind t...

A hinge pin door stop is a swing limiter that mounts to the door's existing butt hinge rather than to the floor, the baseboard or the door face. Th...

A hinge pin door stop is the least invasive way to keep a door from driving its knob into the drywall. The unit clamps to the barrel of an existing...

A wall-mounted door bumper is the simplest form of door protection: a small resilient stop that mounts on the wall surface where the door or its kn...

A convex wall door stop is a surface-mounted bumper that takes the impact of a swinging door before the knob, lever or door edge reaches the wall. ...

A wall-mounted door bumper is the simplest way to stop a swinging door before the knob, lever or edge reaches the wall behind it. The unit fastens ...

A low dome floor stop is the squat, rounded bumper set into the floor behind a swinging door. The dome body takes the strike from the door face or ...

A dome stop is the simplest piece of door hardware there is: a solid, rigid bumper that fastens to the floor behind a swinging door and takes the i...

A flip down door holder, also called a kick down holder, is a surface-mounted device that keeps a swinging door propped open without a separate flo...

A kick-down door holder is a surface-mounted device fastened to the face of a door near the bottom rail. A hinged arm is pivoted down with a foot u...

A hotel door guard is a secondary latching device mounted on the inside face of an entry door and its frame, used in addition to the primary lockse...