Hip and ridge cap shingles are pre-cut, pre-formed cap pieces used to finish the hips and ridges of an asphalt shingle roof. Each piece bends over the peak and seals down with factory-applied adhesive, covering the cut ends of the field shingles and the ridge nailing line where the two roof planes meet.

This bundle is supplied in the Olde English Pewter colour, a grey blend intended to coordinate with grey-toned architectural and three-tab shingle fields. Cap shingles are installed last, working from the end of the ridge opposite the prevailing wind, with each piece lapped to conceal the fasteners of the one before it.

Coverage is sold by the linear foot of hip or ridge rather than by the square, so ridge and hip runs are measured and totalled before ordering.

Key Features

• Pre-cut cap shingles sized to fold over hips and ridges without field cutting
• Factory-applied sealant strip bonds each cap to the one below after exposure to sun
• Olde English Pewter grey colour blend for coordination with grey shingle fields
• Conceals the exposed cut edges of field shingles at the peak
• Nail placement falls under the headlap of the following cap, keeping fasteners covered
• Sold in bundles rated by linear feet of hip and ridge coverage

Applications

• Finishing the main ridge of a new asphalt shingle roof
• Capping hips on hip-roof and dormer construction
• Re-roofing and tear-off work where existing cap is replaced
• Capping over ridge vent where the vent is designed to accept shingle cap
• Repair of storm-damaged or lifted ridge cap on an existing roof

Product Details

• Type: Hip and ridge cap shingles
• Colour: Olde English Pewter
• Material: Asphalt shingle
• Coverage: 30 linear feet per bundle
• Sold By: Bundle

使用此文本分享有关您产品的信息。

使用此文本分享有关您产品的信息。